Junge Arsche -pamsky- Touch Video- 2002 Dvdrip Access

Ricky Bobby · Â #41 Â 10-31-2017, 02:05 PM

I'm at just about 1.5 years with RegFix clips, solid operation of both front windows - I agree with cn90 - if installed properly (seating the cable fully), these should last many years - combined with new black window clips, should be all you need -

Someday when I need to do my rears (those windows barely ever get used) I will do the same -

Sponsored Links

cn90 · Â #42 Â 08-15-2018, 11:12 PM

Hi guys,

I may look at an E70 in the future...

Questions:
- Does the E70 have the same issues of window clips like the E53?
- Any issues with E70 window regulator?

cn90 · Â #43 Â 10-14-2018, 06:57 PM

- Follow-up on post #36 above on Windows Sliding Clips.

- Just did similar Window Sliding Clips on my 2004 BMW X3 (not the same but similar idea)...

- In the photo below that I posed previously, I used a Channel Lock pliers, however, I have found an easier technique: a small C-Clamp. With the C-Clamp, tape a nut on the flat part of the C-Clamp. As you tighten the C-Clamp, use a small screw to help press the metal "ferrule" into the plastic slot.

- The reason for all this C-Clamp business is that: the "Regulator Fix" item was mfg'd with the slot smaller than factory, so it takes work to push the ferrule inward. In a way, this is better b/c when in operation, the ferrule does not pull on the tabs above (on the slider) but this is "friction fit", so the ferrule pulls on the sides of the plastic slot.

- Hope this helps...

- This is the photo that I posted last year using Channel Lock Pliers, but as mentioned above, the C-clamp makes things much easier...

Junge Arsche -Pamsky- Touch Video- 2002 DVDRip

Junge Arsche -Pamsky- Touch Video- 2002 DVDRip

FRod1981 · Â #44 Â 10-15-2018, 12:50 AM

Doing this next

cn90 · Â #45 Â 10-21-2018, 01:11 PM

An little UPDATE...

- In my previous posts, I mentioned using Channel Lock Pliers to squeeze the Cable "Ferrule" inward b/c the RegFix Plastic Clip is tight.

- Now I think it is probably easier with a small C-Clamp + Torx #15 bit.

- Just firmly squeeze it in and make sure you don't break the plastic clip.

- Photo to show the idea of C-Clamp...

StephenVA · Â #46 Â 10-22-2018, 10:09 AM

cn90 · Â #47 Â 10-24-2018, 08:49 PM

- I have a little time, so I get to the bottom of this design and why it fails the way it does...

- If you look at the photos I posted in the original thread, the factory Slider Clip was still intact, although the 2 tabs were a little bent (maybe on the way out...).

- The factory setup is that: the slot is loose and when the glass is going upward, the ferrule pulls on the 2 small tabs on the TOP of the Slider Clips, and over time, these tabs break. A better design is to have beefier tabs on the TOP of the Slider Clips!

- The ebay RegFix White Clip is somewhat interesting. I understand this is aftermarket stuff, the slot was made very tight (probably unintentional but it works in our favor!), I had to use Channel Lock Pliers to squeeze the ferrule in the slot. So for the ebay RegFix White Clip, the SIDEWAY force from the plastic material holds the ferrule in place and there is little force on the 2 tabs on the top. Anyway, this may turn out to last longer b/c the force is NOT on the 2 tabs.

- I took a random photo from the web to show the broken factory clip (Left of photo) and the ebay RegFix White Clip (Right of the photo)...

---

cn90 · Â #48 Â 11-03-2018, 03:06 PM

- I forgot to make a note on the Door Panel Removal...

- The BLACK Rectangular Piece (BLUE Arrow) setup is:
a. Slides into the Door Panel
b. Snap into the Metal Prong (on the door itself)

- During removal: once you pry all the clips out, PULL the Door Panel toward you but LIFT the door UPWARD a bit to disengage the BLACK Rectangular Piece.

- During installation, my trick is...remove the BLACK Rectangular Piece from the Metal Prong: squeeze the metal prong with a pair of pliers to get the BLACK Rectangular Piece out. Now...spread the metal prong tabs outward a bit so it bites on the BLACK Rectangular Piece later. Use a small screwdriver to spread the metal prongs.

- Before you remove the BLACK Rectangular Piece, note the orientation of the BLACK Rectangular Piece (it is NOT symmetrical).

- Now install the BLACK Rectangular Piece on the Door Panel first using a bit of glue or tape to hold it in place.

- During re-installation, just push the Door Panel into the tops 5 tabs (BLUE Circles), the BLACK Rectangular Piece will snap into the metal prong.

---

TiminIndy · Â #50 Â 12-13-2018, 10:48 AM

The early 2000s was a time of significant social and cultural change, with the widespread adoption of the internet and digital technologies. Video sharing and online communities began to play a larger role in shaping popular culture, with many people using these platforms to discover new content, connect with others, and express themselves.

Exploring the Impact of Early 2000s Video Culture

The early 2000s was a pivotal time for video culture, with the rise of digital technology and online sharing. This period saw the emergence of various video formats, including DVDRips, which allowed users to share and distribute content more easily.

DVDRips, short for DVD rips, were a popular way for people to share and access video content during the early 2000s. This format enabled users to rip video content from DVDs and share it online, often through peer-to-peer networks or video sharing platforms.

The early 2000s video culture, including formats like DVDRips, laid the groundwork for the modern digital landscape. The rise of online video sharing and streaming services has transformed the way we consume and interact with video content, with many platforms and services emerging to cater to diverse audiences and interests.

Sponsored Links